Versions Compared

Old Version 4

changes.mady.by.user iarmstrong

Saved on

compared with

New Version 5

changes.mady.by.user iarmstrong

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

RU 🇷🇺

...

Table of Contents

...

The Product Specifications step allows the user to define the rules of the optimisation. Each rule becomes a new row in the Calendar. Values for the rule are specified in Schedule > Calendar > Product Specifications.

Product Specifications use an optimisation engine and lets us to set up a Cash Flow equation, which is the series of cash flows and penalties in the form of targets, which makes a decision when we have multiple destinations available.

...

Adding Product Specification

...

Item

Description

Example

Specify Min

Limits minimum ratio of the material fed from the Source to the Destination.

Note

Crusher feed will be zero if it cannot satisfy a Minimum blend ratio. Make sure there is material available before setting a minimum feed ratio. 

Specify Max

Limits maximum ratio of the material fed from the Source to the Destination.

  • Minimum and Maximum are hard limits, “Actual” values cannot be outside of these boundaries.

    • If Minimum limit cannot be satisfied, the optimiser returns zero.

    • If Maximum limit is reached, no more material can be sent to the specified destination.

  • Note that when setting ratios for multiple plant components, their “Actual” values must add up to 1.

Specify Target

Specifying target also introduces “Content Deviation Penalty” input row in the Calendar.

The difference between the Actual and the Target blend is subject to this Penalty multiplier specified by the user.

The Penalty is summed with the Cash Flows to determine the reward or cost of blending materials into each Destination.

The higher the deviation penalty, the better the optimizer will try to meet the target, but it may not be achieved due to other cash flows and objectives.

Show Tram Lines

Displaying additional guidance rows for the optimisation rule in the Calendar.

Used for visual purposes only to change the color of values in the “Actuals” field, i.e. if it goes out of range by more than 0.0001 it goes red, less than orange, otherwise it's black.

Numerator and Denominator

Blend ratios are calculated using a Numerator and Denominator, as such the setup requires both to be populated.

Note

Never configure the Denominator in a way that could return a zero. If the ratio returns a "divide by zero", then crusher feed will be zero.

Destinations

The Destination(s) to which the blend target is applied.

Quantity Field

The field to which the blend target is applied.

Tip

As a general rule, the Numerator and Denominator should use the same units (either dry tonnes for the strict ratio, or wet tonnes for the weightometer ratio).

Sources

The Source(s) for Numerator and Denominator to which the blend target is applied.

View Database

Use the View Database button to open the Choose Records window, where you can graphically select and review the Sources.

...