Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Type

Message

Next Steps

Dependency

Waiting for mining block to be released by dependencies

Setup > Dependencies > review dependency settings

Dependency

Hit a proximity constraint <PROXIMITY> - so cannot choose block

Drills:

Setup > Dependencies > Drilling > Mining Standoff Distance

Diggers:

Setup > Dependencies > Between Benches > Max Agents on Block

Dependency

Blasting Delay holding up mining of block

Setup > Dependencies > Drilling > Blasting Delay

Setup > Refinements > Custom blast delay inputs (if any)

Agent

Agent cannot operate on the block

Drills:

Setup > Drills > Hole Types > review allowed hole types

Calendar > Drills > check penetration rate greater than zero

Diggers:

Calendar > Agents > check that Agent capacity is greater than zero

Calendar > Incentives > review Maximum/Minimum mining grades

Incentive

Blocked by priority incentive <PRIORITY>

Animation > Priority Incentives > review blockers in the named priority list

Destination Logic

Could not find applicable destination rule

Setup > Destination Logic > review destination logic

Constraint

Constraint <CONSTRAINT> prevented sending to <DESTINATION>

Calendar > Constraints > review constraint limit

Capacity

There is no remaining volume in destination <DESTINATION>

Setup > Waste Dumps > Capacity

Calendar > Dumps > capacity limit

Haul Infinity

Ignored destination due to no travel time available <DESTINATION>

Haul Infinity > Network > invalid cycle time

This may be due to no route available, dynamic haulage stage, and/or rimpull/retard curves on the truck

Equipment

Constraint (Equipment - Step Rule <RULE>) prevented sending to <DESTINATION>

This message indicates that trucks were exhausted in one of the fleets.

  • Setup > Step Logic > review the fleets used in this movement.

  • Setup > Fleets > see what diggers and trucks are assigned.

  • Calendar > Loaders | Trucks | Fleets > find the exhausted equipment.

This message usually results from over-assigning ROM loaders on ex-pit movement, or from exhausting the available rehandle trucks.

Equipment

Blocked due to exhaustion of available equipment

Calendar > Fleets > check number of units available in fleet

*Note
Anchor
note
note

The following error message

...