...
The order of destination rules matters. If the conditions of two rules overlap, the higher rule in the list will be used exclusively.
Ineffective Destination Rule | Don’t do this. If a second rule has the same or fewer conditions than the first, then it will never execute and its destinations will be ignored. |
  | |
Overriding Destination Rule | If special behaviour is required for a specific block or material, then you can “hijack” it by placing the special condition rule higher in the list, and the general condition rule second. |
  | |
Editing
Creating rule
Press the blue plus icon located in the toolbar to add a new rule.
Give the new rule a desired name.
Configure the rule as per the table definitions above.
Place rule into relevant folder.
| Info |
|---|
Rules can be imported and exported from projects using the floppy disk and folder buttons located in the toolbar. |
Copying rule
Hold down the <CTRL> key.
Click and drag on the clipboard icon of that rule.
Drag and hold the cursor over another folder or icon where the new rule will sit. A blue arrow shows where the rule will be inserted.
Release the mouse to drop the new rule.
...