RU 🇷🇺
| Tip |
|---|
Complete the following exercises to practice using tools provided in the Designer tab. |
| Table of Contents |
|---|
Tools
Pick a bench in the level tree and cut up blasts as shown.
Draw Line
Click on the pencil icon or type keyboard shortcut <D>.
Left-click on one side of the bench, outside the boundary line.
Left-click on the other side of the bench, outside the boundary line.
Press <ESC> to finish.
During drawing, the <Backspace> key works as an Undo hotkey.
Move Point
Click the point-move icon or type keyboard shortcut <F>.
Select a point on a line.
Click the new point coordinates to move it there.
Construction lines must form a closed polygon into order to cut solids. This means they must cross another line, or cross through the border polygon.
Offset Lines
Click the line-offset icon or type keyboard shortcut <O>.
Select a line to offset (this may include the bench boundary polygon as shown on the right).
Trim Lines
Click the line-trim icon or or type keyboard shortcut <T>.
Click on a line to trim it back to the nearest intersection.
The Trim tool may not detect an intersection where two closed polygons form an adjacent corner. For these cases, use the Break tool to clear the segment.
Delete Lines
Box-select all lines in the viewport (they will become blue).
Press the <Delete> key or the Delete icon.
Excluding Solids
Even if you have solids selected, the <Delete> key will not delete them (solids). The only way to remove solids is by toggling the Force Exclude property in the Properties panel.
Excluded blocks will be hatched according to the Hatch pattern set in the Setup > Setting.
Undo / Redo
There are two ways to undo/redo changes made in the Designer tab:
Left click in the 3D viewport to activate the area.
Press <CTRL> + <Z> to undo the last change.
Open the History panel in the bottom right of the application.
Click through the history list to see different past states.
Blast Shapes Exercise
|  |
The Generate Blasts window will open.
|  |
Use the top toolbar buttons to manually draw, move, join, and delete points and construction lines. |   |
Double click Mine1\Pit1\Stage1 to center it in the viewport.
|  |
Labels and Shading Exercises
✍🏻 Exercises on how to configure customised labels and shadings can be found in the RR. Exercises section. Please go through them for practicing and a better understanding of the software.