In the Parameters step enter the cycle time parameters for each combination of truck, loader, and material.
Fields with normal black text are editable - you can change values in these rows.
Fields with grey text are calculated – values in these rows vary depending on populated inputs.
Display
In the top left of the parameters table, data can be set to "Iterate" or "Group".
Iterate: update each selected item individually.
Group: update all selected items as a group.
Selections
When items are selected from the Trucks, Loaders and Materials lists in the Selections panel, they are added into the Parameters table.
Hold <CTRL> to select multiple items.
Hold <SHIFT> to select a list of items.
Cycle Time Calculations
Haul Infinity calculates cycle times from first principles using the payloads, swing times, and in-cycle delays.
Loader Payload Calculation
Enter the bucket payload and volume limit.
Haul Infinity calculates the utilized bucket payload.
Truck Payload Calculation
Enter the truck tray payload and volume limit.
Haul Infinity calculates the utilized tray payload.
Loading Calculation
Enter the truck filling type:
“FullBuckets” → less swings to fill the tray, some trucks light-loaded.
“FullTrucks” → more swings to fill the tray, last bucket light-loaded.
“Theoretical” → allow the digger to make "half a swing".
Enter the loader cycle time (time to load one bucket).
Enter the loader first pass delay (time to switch between trucks).
Haul Infinity calculates the corresponding load times.
Detailed instructions on the cycle time calculation see here.
Overrides
The Overrides section can be used to bypass the cycle time calculations.
For most users, Override inputs may be defined as follows:
Loader Load Time = Historical Load Time + Spot Time.
Truck Load Time = Historical Load Time.
Truck Payload = Payload (Ore, Waste).
If you are targeting a specific production rate, use:
Loader Load Time = Truck Payload / Production Rate.
Truck Load Time = Loader Load Time - Spot Time.
Truck Utilized Payload = Payload (Ore, Waste).
Make sure to override both Loader Load Time and Truck Load Time to capture the correct truck and loader rates.
Truck Matching Type
Select the truck matching type:
“OverTruck” → no digger wait time, some truck queue time.
“UnderTruck” → no truck wait time, some loader hang time.
“Round” → some truck queue time, some loader hang time (round the truck numbers to the nearest whole number).
“Theoretical” → zero queue or hang time (uses the theoretical number of trucks without rounding, allowing the fleet to have “half a truck” (a decimal number of trucks).
“TheoreticalNoMinimum” → same as theoretical matching type, but not including minimum waiting time.
Tactical Scheduler users are recommended to use “Theoretical” matching for scheduling.
Queue Time
If queue time is already accounted for in the Time Usage Model, then set:
Truck Matching Type = “Theoretical”.
Minimum Queue Time = 0.
This removes queue time from the Haul Infinity cycle times.
Truck Spot Time At Loader
Enter the truck spotting time for each loader type.
Dumping Time
If the historical truck dumping time includes the dump spot time, be sure to zero the "SpotAtDumpSeconds" property in Crusher/Stockpiles nodes on the network.