TS. Long Term Stockpiles

Create Tables

1. In the Create Tables step in the Type column select “Long Term Stockpile” option. This table type behaves exactly the same as other table types and can be assigned to phases in the “Map Fields” step.

Map Fields

1. In the Map Fields step, map phase as a Long-Term Stockpile.

Preschedule

Phase mapped as long-term stockpile appears as Source and Destination in the Preschedule step.

Destination Logic and Steps Logic

The source and destination phases can be referenced in the Destination Logic and Steps Logic to handle the movements to and from the Long-Term Stockpile.

Phases assigned to this table will be added as both a fillable destination and a reclaimable source.

In the Long Term Stockpiles step each entry in this table consists of a long-term stockpile, reclaim parcel and a trigger condition.

• Reclaim Parcel - The parcel that is reported out in the transactions that occur from mining the stockpile. This is the parcel that the material dumped on the stockpile becomes, so it should be used in the destination logic rule for reclaiming.

• Trigger - The condition that must be satisfied to allow reclaiming to commence. This is the same logic that is applied in Dynamic Haulage rules.

  • AnyMined - The trigger is fired when any ONE of the blocks specified finishes mining,

  • AllMined - The trigger is fired when ALL blocks specified have finished mining.

  • Calendar - To control LTSP reclaiming from the Calendar. Set a value greater than 0 in the periods when you want to start reclaiming.

Long Term Stockpile as a Destination, with Agents filling:

Long Term Stockpile as a Source, with Agents reclaiming:

Create a report to view the tonnes (and parcels) moved to and from the LTSP by period. Filter by LTSP as Source and as Destination to make it easier to view the data. You can also display the applicable destination or step logic rule to validate the setup.