31/8/2022 New Release v22.2.2355

Alastri is pleased to announce the release of v22.2.2355.

Rapid Reserver

Designer
- Fixed an issue where Quick Extend tool in Designer was not working as expected for very minor gaps.
- Fixed an issue where blocks were not responding correctly after applying Grade Control where a dig already had Full Height Dig setting applied.
- Fixed an issue where blocks would not show correctly when using Break Segment to change a polygon to construction lines.
Setup
- Fixed a crash occurring when middle clicking the list of phases on the Phase Exclusion Areas setup task while the cursor was in add polygon points mode in the viewport.
- Fixed a crash occurring when unchecking Use Block Model option in Settings setup task after the setup had already been run.
General
- Fixed an issue where an error would show on saving the project after importing an extremely large layer.

Animation
- Fixed an issue where blocks initial state in Animation were not showing correctly if they had no drilling to be done, but had charging meters

Animation
- Fixed an issue where stockpile point solids were not showing correctly in Animation when reclaiming.

Calibration
- Fixed an issue where the calibration file failed to work as expected.